When to Replace the Strider 14x Chain
The chain on your child's Strider 14x is a wear item that will eventually need replacement. Signs it's time for a new chain include visible rust, stiff links, or the chain skipping during pedaling. Regular inspection, especially after wet or muddy rides, helps catch issues early.
The Strider 14x Chain (product ID 603813) is a replacement chain designed specifically for use with Strider 14x Easy-Ride Pedal Kits. It is sold as a single chain unit and is not a full pedal kit. This chain is intended for maintenance or repair of bikes that already have a Strider 14x Easy-Ride Pedal Kit installed.
Strider 14x Chain at a Glance
- Strider 14x Chain: This replacement chain is designed specifically for use with Strider 14x Easy-Ride Pedal Kits. Ensures you buy the correct chain that fits the bike's drivetrain, avoiding compatibility issues.

Strider 14x Chain - Strider 14x Chain: Sold as a single chain unit. Does not include the complete pedal kit. Helps you understand exactly what you're getting—just the chain, not other pedal kit components.
Chain Maintenance Between Replacements
To extend the life of your Strider 14x chain, keep it clean and lightly lubricated. After each ride, wipe the chain with a dry cloth to remove dirt and moisture. Apply a small amount of bike-specific chain lubricant to the rollers, then wipe off excess to avoid attracting grime.
Check the chain tension periodically. A chain that is too loose may slip off the sprockets, while one that is too tight can cause premature wear on the drivetrain. If you notice unusual noise or resistance, inspect the chain for stiff links or damage.
How to Replace the Strider 14x Chain
Replacing the chain on a Strider 14x is a straightforward task you can do at home with basic tools. Follow these steps for a smooth replacement.
- Gather tools: You'll need a chain tool (for breaking and joining the chain), a pair of pliers, and a clean rag. Make sure you have the new Strider 14x Chain ready.
- Remove the old chain: Use the chain tool to push out one of the chain pins, separating the chain. Slide the old chain off the sprockets and discard it.
- Install the new chain: Thread the new chain around both sprockets (front and rear) following the same path as the old one. Use the chain tool to push the pin back in, joining the chain ends. Ensure the pin is flush with the side plates.
- Check tension and alignment: Rotate the pedals a few times to check that the chain runs smoothly without binding or slack. Adjust the rear wheel position if needed to achieve proper tension.
- Lubricate and test: Apply a drop of lubricant to each chain roller, then wipe off excess. Take the bike for a short test ride to confirm everything works correctly.
What the Supplied Information Does Not Cover
The product record confirms compatibility with Strider 14x Easy-Ride Pedal Kits but does not specify chain length in links or exact installation torque values. These details are typically found in the pedal kit's instruction manual. If you don't have the manual, check the Strider website or contact customer support for guidance.
Also, the chain is sold individually—if you need other drivetrain parts (like a new sprocket or pedal kit), those must be purchased separately. The chain alone is intended for maintenance or repair of an existing Strider 14x Easy-Ride Pedal Kit.

